{"id":25991376,"date":"2026-11-13T07:54:56","date_gmt":"2026-11-13T15:54:56","guid":{"rendered":"https:\/\/dbhorsestable.com\/en\/jump-cups-and-pins-sourcing-spares-that-fit-fei-standard-wings\/"},"modified":"2026-11-13T07:54:56","modified_gmt":"2026-11-13T15:54:56","slug":"jump-cups-and-pins-sourcing-spares-that-fit-fei-standard-wings","status":"publish","type":"post","link":"https:\/\/dbhorsestable.com\/fr\/jump-cups-and-pins-sourcing-spares-that-fit-fei-standard-wings\/","title":{"rendered":"Jump Cups and Pins: Sourcing Spare Parts That Fit FEI-Standard Wings"},"content":{"rendered":"
Jump cups and pins are two of the small parts on a horse jump that get ordered wrong most often. A yard replaces a knocked cup, buys one that looks identical, and finds the new one sits higher on the standard than the one it replaced. The jump leans. The pole rolls at the touch.<\/p>\n\n
Fit is a measurement problem, not a catalog problem. Cups have to match the standard’s hole pitch and the pole’s diameter; pins have to match the hole they pass through and the load they hold. This site publishes none of those dimensions for its FEI-standard jump lines, so the numbers have to come off your own equipment and go onto the order in writing.<\/p>\n\n
\n
Key Takeaways<\/p>\n
\n
A spare cup is specified against the standard it fits, not against the jump you saw at a show \u2014 hole pattern first, pole diameter second, material third. This is fitment and sourcing, not safety inspection.<\/li>\n
Hole pitch \u2014 the vertical spacing of the cup positions up the post \u2014 is what makes a replacement set interchangeable. It is not a published figure here; measure it and put it on the order.<\/li>\n
Pins usually fail through wear and tolerance rather than one dramatic break. A slightly small pin in a worn hole can let the pole lift under a hoof, and nobody notices until a rail drops in a competition round.<\/li>\n
Buy the cup and pin set by the standard you own. Mixing suppliers across one post is where interchangeability tends to break down.<\/li>\n
Spare hardware has no published ordering floor on this site, unlike the fence line’s 50 panels, so state the quantity you need and ask what the actual minimum is.<\/li>\n
Production runs 4-6 weeks globally; expedited orders from Sydney or Warsaw regional stock can run 1-2 weeks where the item is held. That gap is long enough for a broken cup to cost a training week.<\/li>\n<\/ul>\n<\/div>\n\n